Installation

AUDIO / VISUAL: AMPLIFIER ANTENNA: INSTALLATION

1. INSTALL AMPLIFIER ANTENNA ASSEMBLY

(a) Install the 2 bolts and the amplifier antenna assembly.





Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

NOTICE:
* Clean the antenna conductors on the rear window with a non-residue solvent where the contact terminals touch.
* When installing a new amplifier antenna assembly, do not remove the protective cover before installation.
* Do not touch the contact terminals.

(b) Connect each connector.

2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade) Installation

3. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Installation

4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade) Installation

5. INSTALL CENTER STOP LIGHT SET Installation

6. INSTALL REAR SEAT SHOULDER BELT HOLE COVER Installation

7. CONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH Installation

8. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Installation

9. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH Installation

10. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

11. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

12. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH Installation

13. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY RH Installation

14. INSTALL REAR DOOR SCUFF PLATE LH Installation

15. INSTALL REAR DOOR SCUFF PLATE RH Installation

16. INSTALL REAR SEATBACK ASSEMBLY Installation

17. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

18. INSTALL REAR SEAT HEADREST ASSEMBLY

19. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

21. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

22. INSPECT SRS WARNING LIGHT

Diagnosis System