Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: OCCUPANT CLASSIFICATION ECU: INSTALLATION

1. INSTALL OCCUPANT DETECTION ECU

(a) Engage the claw to install the occupant detection ECU.





NOTICE:
If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.

(b) Connect the 2 connectors.

NOTICE:
When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.

2. INSTALL FRONT SEAT ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side Installation.

3. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes