Installation

HYBRID / BATTERY CONTROL: COMBINATION SWITCH: INSTALLATION

1. INSTALL COMBINATION SWITCH ASSEMBLY

(a) Engage the 2 claws to install the transmission shift main switch.

(b) Put the 2 guides in position.





(c) Install the position indicator housing assembly to the combination switch assembly with the 2 screws.

Torque : 0.8 Nm (8 kgf-cm, 7 in-lbf)

(d) Connect each connector.

(e) Engage the clamp.

(f) Engage the 2 guides and 6 claws to install the combination switch assembly.

2. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

3. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY Installation

4. INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH Installation

5. INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH Installation

6. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL Installation

7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE Installation

9. INSTALL DECK FLOOR BOX RH Installation

10. INSTALL REAR NO. 3 FLOOR BOARD Installation

11. INSTALL REAR DECK FLOOR BOX Installation

12. INSTALL REAR NO. 2 FLOOR BOARD Installation