Auto Up Operation Does Not Fully Close Power Window (Jam Protection Function Is Activated)

WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM: Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
- Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

CAUTION / NOTICE / HINT

HINT
This symptom may occur to the right or left door windows.

DESCRIPTION

If the door glass or the power window regulator motor does not operate smoothly, the jam protection function may be triggered automatically, resulting in the AUTO UP function being unable to fully close the window.

INSEPCTION PROCEDURE

PROCEDURE

1. RESET POWER WINDOW REGULATOR MOTOR

(a) Reset the power window regulator motor [1][2]Programming and Relearning.

(b) Check if the power window AUTO UP / DOWN function operates normally.

OK:

AUTO UP / DOWN function operates normally.

OK -- END
NG -- Continue to next step.

2. CHECK DOOR WINDOW REGULATOR

(a) Remove the door glass Overhaul.

(b) Operate the door window regulator using the switch.

(c) Check if the door window regulator operates smoothly.

OK:

Door window regulator operates smoothly.

NG -- REPLACE DOOR WINDOW REGULATOR

OK -- REPLACE DOOR GLASS RUN (ADJUST DOOR GLASS)