Installation

A761E AUTOMATIC TRANSMISSION: TRANSMISSION WIRE: INSTALLATION

1. INSTALL TRANSMISSION WIRE

(a) Coat a new O-ring with ATF and install it to the transmission wire.

(b) Install the transmission wire with the bolt.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(c) Connect the transmission wire connector.

2. CONNECT TRANSMISSION WIRE

(a) Connect the 9 connectors to the solenoid valves.

(b) Install the 2 clamps with the 2 bolts.

Torque : 6.4 Nm (65 kgf-cm, 57 in-lbf for bolt A)

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf for bolt B)

(c) Install the ATF temperature sensor and lock plate with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

(a) Coat a new O-ring with ATF.

(b) Install the O-ring.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

(a) Install the 3 magnets in the oil pan.

(b) Install a new gasket and the oil pan to the transmission case with the 20 bolts.

Torque : 4.4 Nm (45 kgf-cm, 39 in-lbf)

5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY

(a) Install the bracket with the 4 bolts and 2 nuts.

Torque : 43 Nm (438 kgf-cm, 32 ft-lbf)

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. ADD AUTOMATIC TRANSMISSION FLUID

(a) Add automatic transmission fluid Procedures.

8. PERFORM INITIALIZATION

(a) Perform initialization Testing and Inspection.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.