Rear Stabilizer Bar

SUSPENSION: REAR STABILIZER BAR: INSPECTION

1. INSPECT REAR STABILIZER LINK ASSEMBLY LH





(a) As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.

(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Standard turning torque:

0.05 to 1.0 N*m (0.5 10 kgf*cm, 0.4 to 9 in.*lbf)