Installation

SUSPENSION: TOE CONTROL LINK: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Specified Torque For Standard Bolts.
1. TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH





(a) Align the matchmarks on the adjusting cam and suspension member.

(b) Temporarily install the nut, camber adjusting cam No. 2, camber adjusting cam No. 1 and toe control link.

HINT
After stabilizing the suspension, tighten the nuts.

(c) Connect the toe control link to the axle carrier with the nut.

Torque : 59 Nm (600 kgf-cm, 44 ft-lbf)

(d) Connect the rear speed sensor wire to the toe control link with the bolt.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

2. INSTALL REAR WHEEL

(a) Install the wheel with the 5 nuts.

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

3. STABILIZE SUSPENSION Installation

4. TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH

(a) Tighten the nut.

Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)

5. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY

(a) Install the ornament with the 10 bolts.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

6. INSPECT REAR WHEEL ALIGNMENT

(a) Inspect the rear wheel alignment Rear Wheel Alignment.