Installation

SUSPENSION: REAR NO. 2 SUSPENSION ARM: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
* A bolt without a torque specification is shown in the standard bolt chart Specified Torque For Standard Bolts.
1. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

(a) Temporarily install the rear No. 2 suspension arm to the suspension member with the bolt, washer and nut.

HINT
After stabilizing the suspension, tighten the nut.

(b) Install the nut, No. 2 camber adjusting cam and No. 1 camber adjusting cam.





(c) Align the matchmarks on the adjusting cam and rear No. 2 suspension arm.

HINT
After stabilizing the suspension, tighten the nut.

(d) Connect the shock absorber to the rear No. 2 suspension arm with the bolt and nut.

HINT
After stabilizing the suspension, tighten the nut.

(e) Connect the stabilizer link and the height control sensor link to the rear suspension arm No. 2 LH with the bolt and nut.

2. INSTALL REAR WHEEL

(a) Install the wheel with the 5 nuts.

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

3. STABILIZE SUSPENSION Installation

4. TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

(a) Tighten the bolt and nut to the suspension member.

Torque : 110 Nm (1,120 kgf-cm, 81 ft-lbf)

(b) Fix the nut and tighten the bolt to the shock absorber.

Torque : 110 Nm (1,120 kgf-cm, 81 ft-lbf)

NOTICE:
Do not tighten the nut.

(c) Tighten the bolt to the stabilizer link.

Torque : 30 Nm (306 kgf-cm, 22 ft-lbf)

5. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY

(a) Install the ornament with the 10 bolts.

Torque : 20 Nm (204 kgf-cm, 15 ft-lbf)

6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

(a) Inspect and adjust the rear wheel alignment Rear Wheel Alignment.