Removal

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.

1. SHIP MODE SETTING

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Removal

4. REMOVE FRONT DOOR OPENING TRIM COVER LH

5. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

6. REMOVE CONSOLE UPPER PANEL GARNISH REAR Removal

7. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal

8. REMOVE AIR CONDITIONING CONTROL ASSEMBLY Removal

9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER

10. SHIP MODE CONFIRMATION

11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

12. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY Removal

13. REMOVE CONSOLE BOX CARPET

14. REMOVE NO. 3 BOX PANEL Removal

15. REMOVE CONSOLE BOX ASSEMBLY Removal

16. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY

17. REMOVE CENTER AIRBAG SENSOR ASSEMBLY

(a) Remove the 3 clamps from the airbag sensor.





(b) Disconnect the 3 airbag sensor connectors.

(c) Remove the 3 bolts and airbag sensor.