Removal

3UZ-FE COOLING: FAN: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE ENGINE UNDER COVER

3. DRAIN ENGINE COOLANT Service and Repair

4. REMOVE NO. 1 AIR CLEANER INLET Removal

5. REMOVE RADIATOR RESERVE TANK ASSEMBLY

(a) Squeeze the clip and remove the reserve tank inlet hose from the radiator assembly.

(b) Remove the 2 bolts and reserve tank.

6. REMOVE INTAKE AIR CONNECTOR PIPE Removal

7. REMOVE AIR CLEANER ASSEMBLY Removal

8. DISCONNECT NO. 1 RADIATOR HOSE Removal

9. REMOVE ENGINE ROOM ECU OUTLET DUCT

(a) Remove the outlet duct.





10. REMOVE FAN SHROUD SUB-ASSEMBLY

(a) Disconnect the 3 clamps and wire harness from the fan shroud.





(b) Disconnect the 2 connectors.

(c) Remove the 6 bolts and fan shroud.





11. REMOVE COOLING FAN ECU

(a) Disconnect the 2 connectors.





(b) Remove the 2 screws and ECU.

12. REMOVE FAN

(a) Remove the 2 nuts and fan.





13. REMOVE COOLING FAN MOTOR

(a) Disconnect the 2 wires from the fan shroud.

(b) Remove the 3 screws and fan motor.





14. REMOVE NO. 2 COOLING FAN MOTOR

(a) Remove the 3 screws and fan motor.