Removal

CRUISE CONTROL: CRUISE CONTROL MAIN SWITCH: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE NO. 2 STEERING WHEEL COVER LOWER

3. REMOVE SWITCH AND VOLUME CASE

(a) Apply protective tape to the steering wheel boss cover lower as shown in the illustration.

(b) Using a screwdriver, detach the 3 claws and remove the case.

HINT
Tape the screwdriver tip before use.

4. REMOVE STEERING PAD SWITCH MODULATOR

(a) Remove the 2 screws.

(b) Remove the modulator and then disconnect the connector.

5. REMOVE STEERING PAD ASSEMBLY Removal

6. REMOVE STEERING WHEEL ASSEMBLY Removal

7. REMOVE CRUISE CONTROL MAIN SWITCH ASSEMBLY

(a) Remove the 3 screws.

(b) Reverse the steering wheel and remove the 3 screws.