Canada - Interior - Initialization of Front Seat/Seatback
BulletinTSB2701
Issue Date
September 2, 2009
Title
INITIALIZATION OF FRONT SEAT POSITION AND SEATBACK ANGLE
Component
GENERAL INFORMATION
Models
'10 SC430
INTRODUCTION:
This bulletin explains the initialization procedure for the front seat position and the seatback angle on 2010 model year SC 430 vehicles.
To reduce parasitic current draw from the battery during transport and storage, the D.C.C. fuse (15A) has been removed at the assembly plant. As a result of the removal of the D.C.C. fuse, the following will be inoperative:
- Automatic seat adjustment.
- Driving position memory of the front seat.
It is necessary to initialize the front seat position and the seatback angle after the D.C.C. fuse has been installed during Pre-Delivery Service (PDS), or whenever the battery terminal has been disconnected and reconnected.
NOTE
Please refer to TSB No. 2700, "DCC Fuse Installation During PDS," for more information on fuse installation.
APPLICABILITY:
WARRANTY INFORMATION:
INITIALIZATION PROCEDURE:
1. Make sure the DCC fuse is installed in its original position (refer to (TSB No.-2700), "DCC Fuse Installation During PDS").
2. Move the seat position control switch forward until a beeping sound is emitted.
3. Move the seatback angle switch forward until a beeping sound is emitted.
4. Move the seat to the rearmost position, recline the seatback all the way back, and check that the seat will move all the way forward.
NOTE
Repeat the above procedure to initialize the passenger's seat position and seatback angle.