Reassembly

DOOR LOCK: LUGGAGE COMPARTMENT DOOR LOCK: REASSEMBLY

HINT
A bolt without a torque specification is shown in the standard bolt chart Specified Torque For Standard Bolts.

1. INSTALL LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY





(a) Install the lock with the 2 nuts.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

2. INSTALL LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY





(a) Install the cable. Then install the clip to the cable.

(b) Install the bracket with the 2 nuts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(c) Install the cable to the vehicle body with the clamp.

3. INSTALL SPARE WHEEL CARRIER BRACKET





(a) Install the bracket with the 4 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

4. INSTALL LUGGAGE COMPARTMENT REAR TRIM COVER SUB-ASSEMBLY





(a) Install the trim cover and 4 clips.

5. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY





(a) Install the striker LH and RH with the 2 bolts.

6. INSTALL TOOL BOX COVER

(a) Install the cover with the 4 nuts.

7. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH





(a) Install the trim cover and 3 clips.

8. INSTALL LUGGAGE COMPARTMENT TRIM COVER RH

HINT
Use the same procedures for the LH side.

9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

10. INSTALL SPARE DISC WHEEL

11. INSTALL SPARE WHEEL COVER ASSEMBLY

12. INSTALL REAR FLOOR FINISH PLATE





(a) Install the rear floor finish plate and attach the 4 clips.

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

14. PERFORM INITIALIZATION

(a) Perform initialization Testing and Inspection.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.