B15B8

NAVIGATION: NAVIGATION SYSTEM (for HDD): B15B8: Harddisk Malfunction
B15B8 - Harddisk Malfunction

DESCRIPTION

This DTC is stored when the hard disk drive which is built into the display and navigation module display has an initialization malfunction or read/write errors occur more than a specified number of times.





INSEPCTION PROCEDURE

PROCEDURE

1. CHECK HARD DISK DRIVE (OPERATION CHECK)

(a) Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check Operation Check.





(b) Select "HDD Check" and check the result.

OK:

"OK" is displayed.

HINT
* After "HDD Check" is selected, it may take a while until the result is displayed.
* If the cabin temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher, the HDD may not operate normally, and NG may be shown on the display. Make sure to perform the inspection with the cabin at an appropriate temperature.
NG -- REPLACE HARD DISK DRIVE
OK -- Continue to next step.

2. CHECK DTC

(a) Clear the DTC Navigation System (for HDD).

(b) Recheck for DTCs and check if the same trouble occurs again.

OK:

No DTCs are output.

HINT
The hard disk drive may be malfunctioning even if DTC B15B8 is not output.

NG -- REPLACE HARD DISK DRIVE

OK -- USE SIMULATION METHOD TO CHECK How to Proceed with Troubleshooting