Instruments - Compass Calibration Procedure

L-SB-0147-09

October 6, 2009

Initial Calibration of Compass During PDS

Service Category
General

Section
Pre-Delivery Service

Market
USA





Applicability

Introduction





Some 2010 model year LS 460 vehicles are equipped with a compass in the rear view mirror. Use the following procedure to complete initial calibration of the compass during Pre-Delivery Service (PDS).





Warranty Information

Compass Calibration Procedure

1. With foot OFF of the brake pedal press the ENGINE START/STOP button twice to switch to "IG-ON" mode.





2. Push and hold the "AUTO" switch on the mirror for at least 6 seconds until the zone number appears on the compass display.

Pushing the "AUTO" switch for 3 seconds turns the compass display ON or OFF.

3. Once the zone appears, push the "AUTO" switch to select the number of the zone where the vehicle is located.





See the map in figure 3 for zone reference.

4. Depress the brake pedal and press the ENGINE START/STOP switch once to start the engine.





5. Push and hold the "AUTO" switch on the mirror for at least 9 seconds until "CAL appears on the display.





6. Drive the vehicle slowly at 5 mph (8 km/h), or less, in a circle until the direction is displayed. If there is NOT enough space to drive in a circle, drive around the block until the direction is displayed.

Once the direction is displayed, the calibration is complete.

NOTE

^ Do NOT perform calibration of the compass in a place where the Earth's magnetic field is subject to interference (underground parking, under a steel tower; between buildings, roof parking, near a railroad crossing, near a large vehicle, etc.)

^ During calibration, do NOT operate electric systems (moon roof, power windows, etc.) as they may interfere with the calibration.