FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Removal





SEAT: REAR POWER SEAT MOTOR ASSEMBLY (for Ottoman): REMOVAL

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT
* for Power Seat:
* Before removing the rear seat, make sure to move the seat 37 mm (1.46 in.) from the rearmost position.
* for Ottoman:
* Before removing the rear seat, make sure to move the seat 17 mm (0.67 in.) from the rearmost position.
1. REMOVE COWL TOP VENTILATOR LOUVER Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System (for HDD):
* After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Testing and Inspection.
3. REMOVE REAR SEAT CUSHION ASSEMBLY LH Removal

4. REMOVE REAR SEAT CUSHION ASSEMBLY RH Removal

5. REMOVE REAR SEAT CUSHION AIRBAG ASSEMBLY RH Removal

6. REMOVE REAR SEATBACK ASSEMBLY LH Removal

7. REMOVE REAR SEAT CONSOLE BOX (w/ Rear Console Box) Removal

8. REMOVE REAR SEATBACK ASSEMBLY RH Removal

9. REMOVE REAR NO. 2 SEAT ADJUSTER ASSEMBLY

(a) w/ Center Seat:

Remove the nut and anchor part of the rear seat outer belt assembly.





(b) Remove the 4 bolts, nut and seat adjuster.





NOTICE:
Be careful not to damage the vehicle body.

(c) Disconnect the air duct from the vehicle body.

10. REMOVE REAR SEAT BELT INNER ANCHOR BRACKET ASSEMBLY LH Disassembly

11. REMOVE SEAT CLIMATE CONTROL CONTROLLER LH Disassembly

12. REMOVE SEAT CLIMATE CONTROL BLOWER LH Disassembly

13. REMOVE REAR NO. 1 SEAT ADJUSTER ASSEMBLY





(a) Remove the 4 bolts, nut and seat adjuster.

NOTICE:
Be careful not to damage the vehicle body.

(b) Disconnect the air duct from the vehicle body.

14. REMOVE REAR SEAT BELT INNER ANCHOR BRACKET ASSEMBLY RH Reassembly

15. REMOVE SEAT CLIMATE CONTROL CONTROLLER RH Disassembly

16. REMOVE SEAT CLIMATE CONTROL BLOWER RH Disassembly

17. REMOVE REAR SEATBACK ADJUSTER ASSEMBLY RH





(a) Disconnect the connector.

(b) Remove the 4 nuts and seatback adjuster.

NOTICE:
Be careful not to damage the vehicle body.

18. REMOVE REAR SEAT HEADREST ASSEMBLY LH Disassembly

19. REMOVE REAR SEAT HEADREST SUPPORT LH Disassembly

20. REMOVE REAR NO. 1 SEAT HEADREST ADJUSTER SUB-ASSEMBLY LH

(a) Detach the wire harness clamp and disconnect the 2 connectors.





(b) Remove the 2 bolts.

(c) Detach the 2 claws and remove the headrest adjuster.

21. REMOVE REAR SEAT SHOULDER BELT GUIDE ASSEMBLY LH Disassembly

22. REMOVE POSITION CONTROL ECU LH Disassembly

23. REMOVE SEAT CLIMATE CONTROL ECU LH Disassembly

24. REMOVE REAR SEAT COVER CAP LH Disassembly

25. REMOVE SEATBACK COVER WITH PAD LH Disassembly

26. REMOVE REAR SEATBACK CLIMATE CONTROL BLOWER LH Disassembly

27. REMOVE REAR SEAT WIRE LH





(a) Disconnect the connectors.

(b) Detach the wire harness clamps and remove the seat wire.

28. REMOVE REAR SEAT HEADREST ASSEMBLY RH Disassembly

29. REMOVE REAR SEAT HEADREST SUPPORT RH Disassembly

30. REMOVE REAR NO. 1 SEAT HEADREST ADJUSTER SUB-ASSEMBLY RH

HINT
Use the same procedures described for the LH side.

31. REMOVE REAR SEAT SHOULDER BELT GUIDE ASSEMBLY RH Disassembly

32. REMOVE POSITION CONTROL ECU RH Disassembly

33. REMOVE SEAT CLIMATE CONTROL ECU RH Disassembly

34. REMOVE REAR SEAT COVER CAP RH Disassembly

35. REMOVE REAR SEATBACK CLIMATE CONTROL BLOWER RH Disassembly

36. REMOVE SEATBACK COVER WITH PAD RH Disassembly

37. REMOVE REAR SEAT WIRE RH





(a) Disconnect the connectors.

(b) Detach the wire harness clamps and remove the seat wire.