Removal

2GR-FSE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

3. REMOVE NO. 1 INLET AIR CLEANER Removal

4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM Removal

5. REMOVE V-RIBBED BELT Removal

6. REMOVE ENGINE UNDER COVER

7. REMOVE REAR ENGINE UNDER COVER LH

8. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE Removal

9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY Removal

10. REMOVE COMPRESSOR WITH PULLEY ASSEMBLY Removal

11. REMOVE CRANKSHAFT POSITION SENSOR

(a) Disconnect the crankshaft position sensor connector.





(b) Remove the bolt and crankshaft position sensor.