Removal

4GR-FSE STARTING: ENGINE SWITCH: REMOVAL

1. PRECAUTION (W/ Navigation System for HDD)

NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission) Removal

4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transmission) Removal

5. REMOVE UPPER NO. 1 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

6. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH (for Automatic Transmission) Removal

7. REMOVE CONSOLE PANEL SUB-ASSEMBLY (for Automatic Transmission) Removal

8. REMOVE REAR CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

9. REMOVE FRONT CONSOLE PANEL SUB-ASSEMBLY (for Manual Transmission) Removal

10. REMOVE FRONT ASH RECEPTACLE ASSEMBLY Removal

11. REMOVE REAR ASH RECEPTACLE ASSEMBLY Removal

12. REMOVE CONSOLE BOX REGISTER ASSEMBLY Removal

13. REMOVE CONSOLE BOX Removal

14. REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

15. REMOVE CENTER LOWER INSTRUMENT CLUSTER FINISH PANEL Removal

16. REMOVE INTEGRATION CONTROL PANEL WITH RADIO RECEIVER ASSEMBLY (W/O Navigation System) Removal

17. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY (W/ Navigation System) Removal

18. REMOVE ENGINE SWITCH

(a) Disconnect the switch connector.





(b) Detach the 2 claws and remove the switch.