Preparation

1. Confirm condition.
If possible, have customer fill out the Customer Problem Analysis Check Sheet "Noise - Vibration - Harshness"
Refer to ETAS, Bulletin Board > How it works - Customer Problem Analysis Check Sheet "Noise - Vibration - Harshness"








NOTICE
If previous adjustments or repair attempts have been performed, the components need to be returned to their original position(s). This is extremely important for the header lock latch and header lock pin assembly.

2. Follow Repair Manual instructions to remove the components listed below.
Refer to TIS, 2010 model year IS 250C/350C Repair Manual:
A. Vehicle Exterior - Sliding Roof/Convertible - "Sliding Roof/Convertible: Metal top Roof:Removal"
B. Vehicle Interior - Seat - "Seat: Rear Seat Assembly: Removal"
C. Vehicle Interior - Interior Panels/Trim - "Interior Panels/Trim: Roof Headlining (for Front Side): Removal"








HINT

A, B, and C above correspond to the sections cross referenced in the table, "Components to Be Removed".