Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. INSTALL FRONT AIRBAG SENSOR

(a) Check that the engine switch is off.

(b) Check that the battery negative (-) terminal is disconnected.

CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Connect the connector.





(d) Install the front airbag sensor with the 2 bolts.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

NOTICE:
* If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
* When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
(e) Check that there is no looseness in the installation parts of the front airbag sensor.

2. INSTALL HEADLIGHT ASSEMBLY Installation

3. INSTALL FRONT UPPER FENDER PROTECTOR Installation

4. INSTALL ENGINE ROOM SIDE COVER LH (for LH Side) Installation

5. REMOVE ENGINE ROOM SIDE COVER RH (for RH Side) Installation

6. INSTALL FRONT BUMPER ENERGY ABSORBER Reassembly

7. INSTALL FRONT BUMPER ASSEMBLY Installation

8. INSTALL RADIATOR GRILLE PROTECTOR Installation

9. INSTALL COOL AIR INTAKE DUCT SEAL Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

11. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System.

12. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT Adjustments

13. PREPARATION FOR HEADLIGHT AIMING (Using a tester) Adjustments

14. PREPARATION FOR HEADLIGHT AIMING (Using a screen) Adjustments

15. HEADLIGHT AIMING INSPECTION Adjustments

16. HEADLIGHT AIMING ADJUSTMENT Adjustments

17. VEHICLE PREPARATION FOR FOG LIGHT AIM Adjustments

18. PREPARATION FOR FOG LIGHT AIMING Adjustments

19. FOG LIGHT AIMING INSPECTION Adjustments

20. FOG LIGHT ADJUSTMENT Adjustments