Installation

SUSPENSION CONTROL: FRONT ACTIVE STABILIZER CONTROL ECU: INSTALLATION

1. INSTALL FRONT ACTIVE STABILIZER CONTROL ECU

(a) Install the ECU with the bolt and 2 nuts.





Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf for nut)

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf for bolt)

(b) Using the procedures below, connect the ECU connectors.





(1) Connect the ECU connector. (*1)

(2) Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)

(3) Lock the lever's lock. (*3)

(c) Install the ground wire to the ECU with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Connect the wire harness clamp to the bracket.

2. INSTALL NO. 2 COOL AIR INTAKE DUCT

(a) Install the intake duct with the 2 bolts.





3. INSTALL FRONT FENDER LINER RH

4. INSTALL FRONT FENDER WHEEL OPENING MOULDING RH

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.