Installation

AUDIO / VISUAL: STEERING PAD SWITCH: INSTALLATION

1. INSTALL STEERING PAD SWITCH ASSEMBLY

(a) Engage the 2 claws and pin and install the steering pad switch assembly.





(b) Install the screw.

Torque : 2.4 Nm (24 kgf-cm, 21 in-lbf)

(c) Engage the 2 claws and pin and install the steering pad switch assembly.





(d) Install the screw.

Torque : 2.4 Nm (24 kgf-cm, 21 in-lbf)

2. INSTALL LOWER STEERING WHEEL BOSS COVER

(a) Engage the 2 claws.





(b) Install the lower steering wheel boss cover with the 2 screws.

3. INSTALL STEERING SHAKE DAMPER

(a) Install the steering shake damper with the 2 screws.





(b) Engage the 2 harness clamps.

4. INSTALL CRUISE CONTROL MAIN SWITCH Installation

5. ADJUST SPIRAL CABLE with STEERING SENSOR Installation

6. INSTALL STEERING WHEEL ASSEMBLY (for 2GR-FSE) Installation

7. INSTALL STEERING WHEEL ASSEMBLY (for 1UR-FSE) Installation

8. INSTALL STEERING PAD Installation

9. INSTALL LOWER NO. 3 STEERING WHEEL COVER

10. INSTALL LOWER NO. 2 STEERING WHEEL COVER

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

12. INSPECT STEERING PAD Installation

13. INSPECT SRS WARNING LIGHT

Diagnosis System