Installation

PRE-COLLISION: SEAT BELT CONTROL ECU: INSTALLATION

1. INSTALL SEAT BELT CONTROL ECU

(a) Engage the claw to install the seat belt control ECU to the junction block assembly.





NOTICE:
Do not use an ECU that has been dropped or subjected to a strong impact.

(b) Install nut A.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(c) Temporarily install nut B.

(d) Connect the connectors.

(e) Engage the claw.





(f) Pass temporarily installed nut B through the body hole (on the left side of the luggage compartment) and slide the seat belt control ECU downward to position it together with the junction block assembly.





(g) Pass the 2 bolts through the body holes and fully tighten the nuts in the order of D, C and B.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

HINT
Jiggle the seat belt control ECU to check for looseness.

2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER LH Installation

3. INSTALL LUGGAGE COMPARTMENT FRONT TRIM COVER Installation

4. INSTALL REAR FLOOR FINISH PLATE Installation

5. INSTALL TOOL BOX Installation

6. INSTALL TOOL BOX BOARD

7. INSTALL LUGGAGE COMPARTMENT SIDE TRIM COVER LH

8. INSTALL LUGGAGE COMPARTMENT SIDE TRIM COVER RH

9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT Installation