Removal

2GR-FSE ENGINE CONTROL SYSTEM: ENGINE COOLANT TEMPERATURE SENSOR: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE COOL AIR INTAKE DUCT SEAL Removal

4. REMOVE ENGINE ROOM SIDE COVER RH Removal

5. REMOVE ENGINE ROOM SIDE COVER LH Removal

6. REMOVE V-BANK COVER Removal

7. REMOVE FRONT UPPER FENDER PROTECTOR LH Removal

8. REMOVE FRONT UPPER FENDER PROTECTOR RH Removal

9. REMOVE FRONT FENDER TO COWL SIDE SEAL LH Removal

10. REMOVE FRONT FENDER TO COWL SIDE SEAL RH Removal

11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal

12. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal

13. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal

14. DRAIN ENGINE COOLANT Service and Repair

15. DISCONNECT NO. 2 VENTILATION HOSE Removal

16. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE Removal

17. REMOVE THROTTLE BODY Removal

18. REMOVE INTAKE AIR SURGE TANK Removal

19. REMOVE INTAKE MANIFOLD Removal

20. REMOVE ENGINE COOLANT TEMPERATURE SENSOR

(a) Disconnect the sensor connector.

(b) Remove the sensor.