Installation

AXLE: STEERING KNUCKLE: INSTALLATION

1. INSTALL STEERING KNUCKLE

(a) Install the steering knuckle to the upper suspension arm with a castle nut and new clip.





Torque : 87 Nm (887 kgf-cm, 64 ft-lbf)

NOTICE:
If the holes for the clip are not aligned, tighten the nut up to another 60°.

2. INSTALL LOWER BALL JOINT ASSEMBLY FRONT (for 2WD)

(a) Install the steering knuckle to the lower ball joint with the 2 bolts.





Torque : 120 Nm (1220 kgf-cm, 89 ft-lbf)

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY (for 2WD) Installation

4. INSTALL FRONT AXLE HUB SUB-ASSEMBLY (for 4WD) Installation

5. INSTALL TIE ROD ASSEMBLY (for 4WD) Installation

6. INSTALL LOWER BALL JOINT ASSEMBLY FRONT (for 4WD) Installation

7. INSTALL FRONT AXLE HUB NUT (for 4WD) Installation

8. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation

9. INSTALL SPEED SENSOR FRONT (for 2WD) Installation

10. INSTALL SPEED SENSOR FRONT (for 4WD) Installation

11. INSTALL FRONT DISC Reassembly

12. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

13. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT (for 4WD)

Front Wheel Alignment

14. CHECK ABS SPEED SENSOR SIGNAL

(w/ Electronically Controlled Brake System: Test Mode Procedure)

(w/ o Electronically Controlled Brake System: Test Mode Procedure)