Installation

TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION

1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY

(a) Connect the connector to the tire pressure warning receiver assembly.





Text in Illustration

Text in Illustration:

(b) Engage the guide into the hole to temporarily install the tire pressure warning receiver assembly.

(c) Install the 2 nuts.

Torque : 7.5 Nm (77 kgf-cm, 66 in-lbf)

(d) Engage the wire harness clamp to the tire pressure warning receiver assembly.

2. INSTALL ROOF HEADLINING ASSEMBLY

HINT
Refer to the instructions for Installation of the roof headlining assembly Installation.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSPECT TIRE PRESSURE WARNING SYSTEM

(a) Inspect the tire pressure warning system Test Mode Procedure.