Auto Up Operation Does Not Fully Close Power Window (Jam Protection Function Is Activated)

WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM: Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

CAUTION / NOTICE / HINT
HINT: This symptom may occur to the right or left door windows.

DESCRIPTION

If the door glass or the power window regulator motor does not operate smoothly, the jam protection function may be triggered automatically, resulting in the AUTO UP function being unable to fully close the window.

INSPECTION PROCEDURE

PROCEDURE

1. RESET POWER WINDOW REGULATOR MOTOR
(a) Reset the power window regulator motor Initialization.
(b) Check if the power window AUTO UP / DOWN function operates normally.
OK:
AUTO UP / DOWN function operates normally.
OK -- END
NG -- Continue to next step.
2. CHECK DOOR WINDOW REGULATOR
(a) Remove the door glass Disassembly.
(b) Operate the door window regulator using the switch.
(c) Check if the door window regulator operates smoothly.
OK:
Door window regulator operates smoothly.
NG -- REPLACE DOOR WINDOW REGULATOR
OK -- REPLACE DOOR GLASS RUN (ADJUST DOOR GLASS)