Installation

SUSPENSION: FRONT SUSPENSION NO. 2 LOWER ARM: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL FRONT SUSPENSION NO. 2 LOWER ARM SUB-ASSEMBLY LH





(a) Install the front suspension No. 2 lower arm and strut bar bracket with the 2 bolts and nut.
Torque: 164 Nm (1,672 kgf-cm, 121 ft-lbf)for bolt
Torque: 152 Nm (1,550 kgf-cm, 112 ft-lbf)for nut





(b) Install the bolt.
Torque: 58 Nm (590 kgf-cm, 43 ft-lbf)





(c) Install the front suspension member brace with the 4 bolts.
Torque: 56 Nm (570 kgf-cm, 41 ft-lbf)
(d) Connect the front suspension member brace rear with the 2 nuts.
Torque: 58 Nm (590 kgf-cm, 43 ft-lbf)
2. INSTALL FRONT WHEEL
(a) Install the wheel with the 5 nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
3. STABILIZE SUSPENSION.
4. INSTALL WHEEL HUB ORNAMENT SUB-ASSEMBLY
(a) Install the wheel with the 5 nuts.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(a) Inspect and adjust the front wheel alignment Front Wheel Alignment.