Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

INSTALLATION
CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it Service Precautions.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. INSTALL REAR AIRBAG SENSOR LH





(a) Install the sensor with the 3 nuts.
Torque: 20 Nm (204 kgf-cm, 14 ft-lbf)
- If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(b) Check that there is no looseness in the installation parts of the airbag sensor.
(c) Connect the sensor connector.
2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH Installation
3. INSTALL DOOR SCUFF PLATE ASSEMBLY LH Installation
4. INSTALL REAR SEATBACK ASSEMBLY Installation
5. INSTALL REAR SEAT HEADREST ASSEMBLY Installation
6. INSTALL REAR SEAT HEADREST PLATE Installation
7. INSTALL WIND DEFLECTOR BOARD ASSEMBLY Installation
8. INSTALL REAR SEAT HEADREST PLATE COVER Installation
9. INSTALL REAR SEAT CUSHION ASSEMBLY Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

12. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.