Installation

3UZ-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL CRANK POSITION SENSOR





(a) Install the sensor with the bolt.
Torque: 6.5 Nm (66 kgf-cm, 57 in-lbf)
(b) Connect the sensor connector.
2. INSTALL ENGINE UNDER COVER Installation
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.