Installation

BRAKE CONTROL: FRONT SPEED SENSOR: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT SPEED SENSOR LH





(a) Install the sensor with the bolt.
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
(b) Install the sensor harness with the 2 clamp bolts and resin clip.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)





(c) Connect the sensor connector.
2. INSTALL FRONT FENDER LINER LH
3. INSTALL FRONT WHEEL
(a) Install the wheel with the 5 nuts.
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)
(b) Install the ornament with the 10 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
4. CHECK ABS SPEED SENSOR SIGNAL
(a) Check the ABS speed sensor signal Test Mode Procedure.