Removal

AUDIO / VISUAL: NETWORK GATEWAY ECU: REMOVAL

REMOVAL

1. TABLE OF BOLT, SCREW AND NUT Removal
2. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

4. INSPECT CENTER FRONT WHEEL
5. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
(a) Remove the instrument panel safety pad Removal.
6. REMOVE STEERING COLUMN ASSEMBLY Disassembly
7. REMOVE NO. 1 INSTRUMENT PANEL PIN Disassembly
8. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT Disassembly
9. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT Disassembly
10. REMOVE FRONT DEFROSTER NOZZLE Disassembly
11. REMOVE NO. 1 HEATER TO REGISTER DUCT Disassembly
12. REMOVE NO. 3 HEATER TO REGISTER DUCT Disassembly
13. REMOVE NO. 2 HEATER TO REGISTER DUCT Disassembly
14. REMOVE INSTRUMENT PANEL REINFORCEMENT Disassembly
15. REMOVE NETWORK GATEWAY ECU





(a) Remove the 2 screws and ECU.