Navigation System: Adjustments

NAVIGATION: NAVIGATION SYSTEM: ADJUSTMENT

ADJUSTMENT
HINT:
- After replacing the multi-display or the navigation ECU, the screen's display may be affected by noise. Perform the adjustment below to reduce screen noise.
- Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be shown exactly the same as on the actual vehicle.
- Perform both procedures below when the multi-display is replaced.

1. HOW TO PERFORM SCREEN NOISE AUTOMATIC ADJUSTMENT
(a) When either the multi-display or the navigation ECU is replaced:




(1) Turn the ignition switch to ACC and wait for at least 6 seconds to activate the diagnostic mode Reading and Clearing Diagnostic Trouble Codes.
(2) Select "Navigation Check" from the "Diagnosis MENU" screen.




(3) The screen enters "Navigation Check" with a beeping sound. Adjustment is completed when the completion mark is displayed.
(4) Cancel the diagnostic mode Reading and Clearing Diagnostic Trouble Codes.