Removal

ENGINE IMMOBILIZER: TRANSPONDER KEY ECU: REMOVAL

REMOVAL

1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. INSPECT CENTER FRONT WHEEL
4. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
(a) Remove the instrument panel safety pad Removal.
5. REMOVE STEERING COLUMN ASSEMBLY Disassembly
6. REMOVE NO. 1 INSTRUMENT PANEL PIN Disassembly
7. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT Disassembly
8. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT Disassembly
9. REMOVE FRONT DEFROSTER NOZZLE Disassembly
10. REMOVE NO. 1 HEATER TO REGISTER DUCT Disassembly
11. REMOVE NO. 3 HEATER TO REGISTER DUCT Disassembly
12. REMOVE NO. 2 HEATER TO REGISTER DUCT Disassembly
13. REMOVE INSTRUMENT PANEL REINFORCEMENT Disassembly





14. REMOVE TRANSPONDER KEY ECU ASSEMBLY
(a) Remove the 2 screws and ECU.