Installation

AA80F AUTOMATIC TRANSMISSION: PARK / NEUTRAL POSITION SWITCH: INSTALLATION

INSTALLATION

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Install the switch to the manual valve shaft.

(b) Temporarily install the bolt.

(d) Temporarily install the control shaft lever.

(e) Turn the control shaft lever counterclockwise until it stops, and then turn it clockwise 2 notches to set it to the N position.
(f) Remove the control shaft lever.

(g) Align the neutral basic line with the groove.
(h) Hold the switch in position and tighten the bolt.
Torque: 13 Nm (130 kgf-cm, 9 ft-lbf)

(i) Using a screwdriver, bend the tabs of the lock washer.
HINT: Bend at least 2 washer tabs.

(j) Install the transmission control shaft lever and spring washer with the nut.
Torque: 16 Nm (160 kgf-cm, 12 ft-lbf)
(k) Connect the switch connector.

2. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Temporarily connect the shifting rod to the connecting rod swivel with the nut.
HINT: The nut is tightened to a torque specification during the shift lever position adjustment procedure.

3. ADJUST SHIFT LEVER POSITION
(a) Adjust the shift lever position AA80F Automatic Transmission.
4. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation
5. INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Install the front exhaust pipe Installation.
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

7. INSTALL COWL TOP VENTILATOR LOUVER Installation
8. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Inspect the switch On-Vehicle Inspection.