Flex Plate

Drive plate and ring gear x crankshaft 30 Nm (301 kgf-cm, 22 ft.lbf)





Install the sensor rotor.
HINT: Align the pin of the front spacer with the pin hole of the crankshaft.

Install the drive plate and spacer plate on the crankshaft.





Apply a few drops of adhesive to 2 or 3 threads of the bolt end. Adhesive
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent





Uniformly install and tighten 10 new bolts in the sequence shown in the illustration.

Torque: 30 Nm (301 kgf-cm, 22 ft-lbf)
- Do not reuse the drive plate installation bolts.
- Do not impact or damage the drive plate installation bolts. Be sure to handle them carefully.





Mark the upside of each drive plate installation bolt with paint.
Retighten the drive plate installation bolts by 90° as shown.
Check that the painted marks are now at a 90° angle to the upside.