On-Vehicle Inspection

LIGHTING: HAZARD WARNING SWITCH: ON-VEHICLE INSPECTION

ON-VEHICLE INSPECTION





1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
(a) Connect the voltmeter's positive (+) lead to terminal Lr1-2, 3, 4 and negative (-) lead to terminal Lr1-6.
(b) Measure the voltage according to the value(s) in the table below.
Standard voltage:






(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:





- If the result is not as specified, replace the hazard warning signal switch.