Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION

1. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY





(a) Connect the connector.
NOTE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the front passenger side knee airbag with the 3 bolts attach the claw.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
2. INSTALL LOWER INSTRUMENT PANEL





(a) Attach the 1 clips and the 2 claws to install the panel.
3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
4. INSTALL INSTRUMENT SIDE PANEL RH Installation
5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
(a) Perform initialization How To Proceed With Troubleshooting.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

8. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light How To Proceed With Troubleshooting.