Installation

1UR-FSE ENGINE CONTROL SYSTEM: ACCELERATOR PEDAL: INSTALLATION

INSTALLATION





1. INSTALL ACCELERATOR PEDAL
- Avoid physical shocks to the accelerator pedal.
- Do not disassemble the accelerator pedal assembly.

(a) Connect the tip of the accelerator pedal rod to the bracket.
(b) Install the accelerator pedal with the 3nuts.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Connect the accelerator pedal sensor connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
4. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.