Section 3: Front Brake Bleed - Manual Process

NOTE

^ Keep doors closed during bleeding.

^ Ignition must be ON before starting this procedure.

1 Connect a clear vinyl tube to the FR (Front Right) bleeder screw.

2. Pump and hold pressure on the brake pedal while an assistant opens the bleeder screw.

NOTE
Make sure fluid level in reservoir does NOT fall below the low mark during this procedure.

3. When fluid/air bubbles stop coming out tighten the bleeder screw and then release the brake pedal.

4. Repeat steps 2 and 3 until all air is removed from the FR line.

5. Connect a vinyl tube to the FL (Front Left) bleeder screw.

6. Repeat steps 2 and 3 until all air is removed from the FL line.

7. Press the "Engine Start/Stop" button to the ignition OFF position.





8. Connect the accumulator pump electrical connectors.

9. Press the "Engine Start/Stop" button to the ignition ON position.

IMPORTANT

^ Accumulator pressure must be approximately 0.5 volts before starting the rear brake bleed procedure.

^ You should NOT hear the accumulator pump motor run after the ignition is turned ON. If the accumulator pump runs after ignition is turned ON, return to "Section 1: Zero Down Accumulator Pressure".





10. Check and adjust the brake fluid level to MAX.