Installation

LIGHTING: HAZARD WARNING SWITCH: INSTALLATION

INSTALLATION

1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY





(a) Attach the 2 claws and install the hazard warning signal switch.
(b) Connect the connector.
2. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (W/O Multi-display) Installation
3. INSTALL MULTI-MEDIA MODULE DISPLAY ASSEMBLY (W/ Multi-display) Installation
4. INSTALL RADIO RECEIVER ASSEMBLY Installation
5. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER Installation
6. INSTALL REAR CONSOLE PANEL UPPER Installation
7. INSTALL NO. 3 BOX PANEL Installation
8. INSTALL SHIFT LEVER KNOB Installation
9. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
12. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
13. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.