Installation

SEAT: AIR HOSE (for Ottoman): INSTALLATION

INSTALLATION
HINT: A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL AIR HOSE





(a) Attach the 2 claws and install the air hose.
(b) Install the 2 hose clamps and bolt.
Torque: 9.8 Nm (100 kgf-cm, 87 in-lbf)





(c) Install the 2 hose clamps and connect the air hose connector.
2. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Installation
3. INSTALL ROOF SIDE NO. 2 AIR DUCT LH (W/ Rear Cooler) Installation
4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH Installation
5. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Installation
6. INSTALL REAR FLOOR FINISH PLATE Installation
7. INSTALL LUGGAGE COMPARTMENT TRIM COVER SUB-ASSEMBLY FRONT Installation
8. INSTALL NO. 1 COOLER COVER (W/ Rear Cooler) Installation
9. INSTALL LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (W/O Rear Cooler) Installation
10. INSTALL LUGGAGE COMPARTMENT LIGHT ASSEMBLY Installation
11. INSTALL DECK TRIM SIDE BOARD LH Installation
12. INSTALL DECK TRIM SIDE BOARD RH Installation
13. INSTALL ROPE HOOK ASSEMBLY Installation
14. INSTALL ROPE HOOK Installation
15. INSTALL LUGGAGE COMPARTMENT FLOOR MAT SUB-ASSEMBLY Installation
16. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
(a) W/ Rear Sunshade:
Install the package tray trim panel Installation.
(b) W/O Rear Sunshade:
Install the package tray trim panel Installation.
17. INSTALL ROOF SIDE INNER GARNISH RH Installation
18. INSTALL ROOF SIDE INNER GARNISH LH Installation
19. INSTALL REAR SEAT SIDE GARNISH RH Installation
20. INSTALL REAR SEAT SIDE GARNISH LH Installation
21. INSTALL REAR DOOR SCUFF PLATE RH
(a) Use the same procedures described for the LH side.
22. INSTALL REAR DOOR SCUFF PLATE LH Installation
23. INSTALL REAR SEATBACK ASSEMBLY RH Installation
24. INSTALL REAR SEAT CONSOLE BOX ASSEMBLY Installation
25. INSTALL REAR SEATBACK ASSEMBLY LH Installation
26. INSTALL REAR SEAT CUSHION ASSEMBLY RH Installation
27. INSTALL REAR SEAT CUSHION ASSEMBLY LH Installation
28. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
29. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
30. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.

31. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Diagnosis System.