Installation

DOOR LOCK: ENTRY LOCK AND UNLOCK SWITCH (for Rear): INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH [1][2]Installation
2. INSTALL REAR DOOR OUTSIDE HANDLE COVER LH [1][2]Installation
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH [1][2]Installation
4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH [1][2]Installation
5. INSTALL REAR DOOR GLASS RUN LH [1][2]Installation
6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH [1][2]Installation
7. INSTALL RR DOOR DIVISION BAR BRACKET LWR LH [1][2]Installation
8. INSTALL REAR DOOR SERVICE HOLE COVER LH [1][2]Installation
9. INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH [1][2]Installation
10. INSTALL SIDE TRIM BOARD COVER REAR LH (W/ Rear Door Sunshade) [1][2]Installation
11. INSTALL NO. 1 AUTO CURTAIN RAIL BRACKET LH (W/ Rear Door Sunshade) [1][2]Installation
12. INSTALL REAR LH CURTAIN SUB-ASSEMBLY (W/ Rear Door Sunshade) [1][2]Installation
13. INSTALL REAR DOOR NO. 2 FRAME GARNISH LH [1][2]Installation
14. INSTALL REAR DOOR FRAME GARNISH LH [1][2]Installation
15. INSTALL REAR DOOR TRIM COVER LH [1][2]Installation
16. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH [1][2]Installation
17. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR [1][2]Installation
18. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH [1][2]Installation
19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
20. INSTALL COWL TOP VENTILATOR LOUVER RH Installation
21. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.