Removal

DOOR LOCK: ENTRY LOCK AND UNLOCK SWITCH (for Front): REMOVAL

REMOVAL
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH [1][2]Removal
4. REMOVE FRONT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY LH [1][2]Removal
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH [1][2]Removal
6. REMOVE FRONT DOOR SERVICE HOLE COVER LH [1][2]Removal
7. REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH [1][2]Removal
8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH [1][2]Removal
9. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH [1][2]Removal
10. REMOVE FRONT OUTSIDE DOOR HANDLE ASSEMBLY LH [1][2]Removal