Removal

CELLULAR COMMUNICATION: MAYDAY BATTERY: REMOVAL

REMOVAL

1. REMOVE COWL TOP VENTILATOR LOUVER RH Removal
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

3. REMOVE NO. 1 COOLER COVER (W/ Rear Cooler) Removal
4. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
5. REMOVE ROPE HOOK ASSEMBLY Removal
6. REMOVE ROPE HOOK Removal
7. REMOVE DECK TRIM SIDE BOARD LH Removal
8. REMOVE DECK TRIM SIDE BOARD RH Removal
9. REMOVE LUGGAGE COMPARTMENT NO. 1 LIGHT ASSEMBLY Removal
10. REMOVE LUGGAGE COMPARTMENT NO. 2 TRIM HOOK (W/O Rear Cooler) Removal
11. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT Removal
12. REMOVE REAR FLOOR FINISH PLATE Removal
13. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Removal
14. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH Removal





15. REMOVE MAYDAY BATTERY
(a) Disconnect the connector.
(b) Remove the nut, upper bracket and battery.





16. REMOVE LOWER BRACKET
(a) Remove the 2 nuts and bracket.
(b) Disconnect the clamp.