Installation

A960E AUTOMATIC TRANSMISSION: TRANSMISSION WIRE: INSTALLATION

INSTALLATION

1. INSTALL TRANSMISSION WIRE





(a) Coat a new O-ring with ATF and install it to the transmission wire.





(b) Install the transmission wire with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
(c) Connect the transmission wire connector.
2. CONNECT TRANSMISSION WIRE





(a) Connect the 9 connectors to the solenoid valves.





(b) Install the ATF temperature sensor with the bolt.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)





(c) Install the 2 clamps with the 2 bolts.
Bolt A - Torque: 6.4 Nm (65 kgf-cm, 57 in-lbf)
Bolt B - Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY





(a) Coat a new O-ring with ATF.
(b) Install the O-ring.





(c) Install the oil strainer with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY





(a) Install the 3 magnets in the oil pan.





(b) Install a new gasket and the oil pan to the transmission case with the 20 bolts.
Torque: 4.4 Nm (45 kgf-cm, 39 in-lbf)
5. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Installation
6. ADD AUTOMATIC TRANSMISSION FLUID
Procedures
7. INSTALL NO. 2 ENGINE UNDER COVER
8. RESET MEMORY
Programming and Relearning