Removal

A960E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE COOL AIR INTAKE DUCT SEAL Removal
3. REMOVE ENGINE ROOM SIDE COVER LH Removal
4. REMOVE ENGINE UNDER COVER
5. REMOVE NO. 2 ENGINE UNDER COVER
6. DRAIN COOLANT Testing and Inspection
7. DRAIN AUTOMATIC TRANSMISSION FLUID Removal
8. REMOVE NO. 1 FLOOR UNDER COVER Removal
9. REMOVE NO. 2 FLOOR UNDER COVER Removal
10. REMOVE NO. 1 REAR FLOOR PANEL BRACE Removal
11. REMOVE FRONT CENTER FLOOR BRACE Removal
12. REMOVE OXYGEN SENSOR Removal
13. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal
14. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR Removal
15. REMOVE OUTSIDE AIR GUIDE PLATE RH Removal
16. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Removal
17. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH Removal
18. REMOVE STARTER ASSEMBLY Removal
19. REMOVE FLYWHEEL HOUSING SIDE COVER Removal
20. REMOVE DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Removal
21. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Removal
22. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Removal
23. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY Removal
24. REMOVE ENGINE REAR MOUNTING MEMBER Removal
25. SEPARATE CONNECTOR Removal
26. SEPARATE WIRE HARNESS Removal
27. SEPARATE WATER BY-PASS HOSE Removal
28. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY Removal
29. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR Removal
30. REMOVE TRANSMISSION CONTROL SHAFT LEVER RH Removal
31. REMOVE TRANSMISSION OIL COOLER Removal
32. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY Removal
33. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY Testing and Inspection