Installation

A960E AUTOMATIC TRANSMISSION: TORQUE CONVERTER AND DRIVE PLATE: INSTALLATION

INSTALLATION

1. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY Installation
2. INSTALL TRANSMISSION OIL COOLER Installation
3. INSTALL TRANSMISSION CONTROL SHAFT LEVER RH Installation
4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR Installation
5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY Installation
6. INSTALL WATER BY-PASS HOSE Installation
7. INSTALL WIRE HARNESS Installation
8. INSTALL CONNECTOR Installation
9. INSTALL ENGINE REAR MOUNTING MEMBER Installation
10. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY Installation
11. INSTALL NO. 1 EXHAUST PIPE SUPPORT BRACKET SUB-ASSEMBLY Installation
12. INSTALL DRIVE PLATE & TORQUE CONVERTER CLUTCH SETTING BOLT Installation
13. INSTALL STARTER ASSEMBLY Installation
14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH Installation
15. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY Installation
16. INSTALL OUTSIDE AIR GUIDE PLATE RH Installation
17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
18. ADJUST SHIFT LEVER POSITION Adjustments
19. INSPECT SHIFT LEVER POSITION Shift Lever Assembly
20. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR Installation
21. INSTALL FRONT EXHAUST PIPE ASSEMBLY Installation
22. INSTALL OXYGEN SENSOR Installation
23. INSTALL FRONT CENTER FLOOR BRACE Installation
24. INSTALL NO. 1 REAR FLOOR PANEL BRACE Installation
25. INSTALL NO. 2 FLOOR UNDER COVER Installation
26. INSTALL NO. 1 FLOOR UNDER COVER Installation
27. ADD COOLANT
Testing and Inspection
28. ADD AUTOMATIC TRANSMISSION FLUID
Procedures
29. ADJUST COOLANT
Testing and Inspection
30. CHECK FOR ENGINE COOLANT LEAKS Testing and Inspection
31. CHECK FOR EXHAUST GAS LEAKS Installation
32. INSTALL NO. 2 ENGINE UNDER COVER
33. INSTALL ENGINE UNDER COVER
34. INSTALL ENGINE ROOM SIDE COVER LH Installation
35. INSTALL COOL AIR INTAKE DUCT SEAL Installation
36. RESET MEMORY
Programming and Relearning