Removal

4GR-FSE FUEL: FUEL PRESSURE SENSOR: REMOVAL

REMOVAL

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal
2. REMOVE ENGINE ROOM SIDE COVER LH Removal
3. REMOVE ENGINE ROOM SIDE COVER RH Removal
4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal
5. REMOVE FRONT UPPER FENDER PROTECTOR LH Removal
6. REMOVE FRONT UPPER FENDER PROTECTOR RH
HINT:
Removal procedure of the RH side is the same as that of the LH side.

7. REMOVE ROOF DRIP SIDE FINISH MOULDING LH
8. REMOVE ROOF DRIP SIDE FINISH MOULDING RH
HINT:
Removal procedure of the RH side is the same as that of the LH side.

9. REMOVE FRONT WIPER ARM HEAD CAP Removal
10. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH Removal
11. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH Removal
12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Removal
13. DISCHARGE FUEL SYSTEM PRESSURE
HINT:
Service Precautions.

14. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
15. DRAIN ENGINE COOLANT Testing and Inspection
16. DISCONNECT NO. 2 VENTILATION HOSE Removal
17. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE ASSEMBLY Removal
18. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY Removal
19. REMOVE COLD START INJECTOR Removal
20. REMOVE INTAKE AIR SURGE TANK Removal
21. REMOVE INTAKE MANIFOLD Removal
22. DISCONNECT WATER HOSE JOINT Removal
23. REMOVE NO. 1 FUEL PIPE Removal





24. REMOVE FUEL PRESSURE SENSOR
(a) Disconnect the connector and clamp.
(b) Remove the fuel pressure sensor and gasket.