Installation

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR





(a) Connect the connector.





(b) Install the yaw rate and acceleration sensor with the 2 bolts.
Torque: 15 Nm (148 kgf-cm, 11 ft-lbf)
- Do not damage the yaw rate and acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.

(c) Install the 2 wire harness clamps.
2. INSTALL NO. 2 REAR AIR DUCT (for Automatic Transmission) Installation
3. INSTALL NO. 2 REAR AIR DUCT (for Manual Transmission) Installation
4. INSTALL CONSOLE BOX
HINT:
Refer to the instructions for installation of the console box Installation.

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
HINT:
Programming and Relearning.

7. INSPECT SENSOR SIGNAL
HINT:
Test Mode Procedure.